Forklift
Forklift
🤚 Tool Info
Certification Required
🤚 Do Not Hack
🐾 Owner: Geo
Congratulations! You are now in charge of the woodworking tools in the blue cabinet!
This is a basic template with sections useful for most tools requiring a sign-off ("Red" tools). Use this as the basis for a new tool's wiki page.
It may be useful to link to the manufacturer's documentation, but these pages may also include any quirks and features of the tool, as it pertains to use in our hackerspace.
Description
It's a forklift. It picks things up and puts them down. It's also an extremely hazardous tool that must be handled appropriately.
Certification and training is a hard requirement for using this tool. Operating the forklift without certification may lead to immediate dismissal from the space.
Specifically, our forklift is a Hyster A30XL from 1988. It as the following specs:
- Upgrades: side-shift (reduces maximum load capacity by ~200lbs)
- Max load at 20" center: 2800lbs (3000-200)
- Max load at 24" center: 2500lbs (2700-200)
- Max load at 27" center: 2200lbs (2400-200)
- Total unit weight: 7124lbs
- Back-tilt: 6 degrees
- Maximum reach height: 14'
- Drive tread width: 39.3"
- Battery: 24v lead acid (1367 to 1764 lbs)
Safety and Certification
Specify what PPE is required to safely use this tool.
- Which way does the pointy end go?
Hazards
These tools might hurt you or others, take special care to call out what specific dangers the tools present.
Prohibited Operations
Pre-flight checklist
Operation checklist
Post-flight checklist
Certified Members
| Member Name | Certified By | Date |
|---|---|---|
| Geo | Klaus | 2026-10-30 |
Maintenance
Battery Charging
Battery charging can be rather dangerous and should be handled by the forklift manager (currently Geo).
The forklift should generally only be charged when needed (i.e. no "topping up") to prolong battery life.
The forklift manager will check the state of the battery on a regular cadence (currently every Tuesday).
The following charging procedure should be used:
- Position the forklift outside, in front of the roll-up door.
- Ensure the forklift is properly parked and turned off,
- Lift the seat to expose the battery.
- Disconnect the battery from the forklift.
- Connect the battery to the charger.
- The charger should start a charge cycle.
- NEVER disconnect the battery while it is charging!
- If possible, allow a full charge cycle to complete.
- If not possible, press the momentary power switch on the charger to end the charging cycle.
- Wait for the charger to display "end" before disconnecting.
- Return the forklift to the forklift hole.
Battery watering
Tool History
| Date | Event |
|---|---|
| 2026-10-29 | Forklift spawned |